Perform the following command to remove an interface from the port channel group.
Port-channel Module Admin Status is enabled
Port-channel Module Oper Status is enabled
Port-channel recovery action on exceeding Threshold is None
Port-channel Independent mode is disabled
Port-channel System Identifier is 00:55:44:33:22:11
LACP System Priority: 20
LACP Error Recovery Time: 0
LACP Error Recovery Threshold: 5
LACP Recovery Triggered count: 0
LACP Error Recovery Threshold for Defaulted State : 5
LACP Error Recovery Threshold for Hardware Failure : 5
LACP Same state threshold : 5
Channel Group Listing
---------------------
Group: 1
----------
Protocol :LACP
Ports in the Group
------------------
Port : Gi0/2
-------------
Port State = Down, Not in Bundle
Reason for port-down : Oper status of the port is down
Channel Group : 1
Mode : Active
Port-channel = Null
Pseudo port-channel = Po1
LACP port-priority = 128
LACP Wait-time = 2 secs
LACP Port Identifier = 2
LACP Activity : Active
LACP Timeout : Long
LACP Error State : None
Aggregation State : Aggregation, Defaulted
Port : Gi0/24
-------------
Port State = Up in Bundle
Channel Group : 1
Mode : Active
Port-channel = Po1
Pseudo port-channel = Po1
LACP port-priority = 20
LACP Wait-time = 1 secs
LACP Port Identifier = 24
LACP Activity : Active
LACP Timeout : Short
LACP Error State : None
Aggregation State : Aggregation, Sync, Collecting, Distributing, Defaulted
LACP Port Admin Oper Port Port
Port State Priority Key Key Number State
---------------------------------------------------------------------
Gi0/2 Down 128 1 1 0x2 0xa2
Gi0/24 Bundle 20 1 1 0x18 0xbe
Port-channel : Po1
-------------------
Number of Ports = 3
HotStandBy port = null
Port state = Port-channel Ag-Inuse
Protocol = LACP
Aggregator-MAC e8:e8:75:90:5f:9d
Maximum number of Ports = 8
Port-Channel Mtu = 1500
Port-Channel Speed = 1000 Mbps
Port-Channel High Speed = 1000 Mbps
Port-Channel Member Ports Speed = 1000 Mbps
Port-Channel Member Ports High Speed = 1000 Mbps