unicast-mac learning limit

To configure the unicast- MAC learning limit for a switch, use the command unicast-mac learning limit in VLAN Configuration Mode. The no form of the command resets the unicast- MAC learning limit for the switch to its default value.

unicast-mac learning limit

unicast-mac learning limit { <limit value(0-4294967295)> }

no unicast-mac learning limit

unicast-mac learning limit

Parameters

Parameter	Type	Description
`<limit value(0-4294967295)>`	Integer	Enter a value for the learning limit. The limit represents the maximum number of distinct unicast MAC addresses that can be learnt in the switch. This value ranges from 0 to 4294967295.

Mode

VLAN Configuration Mode

Default

The maximum limit supported by the switch.

Prerequisites

The limiting value should not be less than the unicast MAC learning limit set for any of the VLAN.
Unicast-MAC learning limit cannot be configured in the switch, if the VLAN switching feature is shutdown in the switch.

Examples

iS5Comm (config-vlan)# vlan unicast-mac learning limit 300