To display the current information stored in the NVRAM (nonvolatile random-access memory), use the command show nvram in Privileged EXEC Mode.
Privileged EXEC Mode
Default IP Address : 192.168.10.1
Default Subnet Mask : 255.255.255.0
Default IP Address Config Mode : Manual
Default IP Address Allocation Protocol : DHCP
Switch Base MAC Address : e8:e8:75:90:0b:01
Default Interface Name : Gi0/1
Default RM Interface Name : NONE
Config Restore Option : No restore
Config Save Option : No save
Auto Save : Disable
Incremental Save : Disable
Roll Back : Enable
Config Save IP Address : 0.0.0.0
Config Save Filename : iss.conf
Config Restore Filename : iss.conf
PIM Mode : Sparse Mode
IGS Forwarding Mode : MAC based
Cli Serial Console : Yes
SNMP EngineID : 80.00.08.1c.04.46.53
SNMP Engine Boots : 985
Default VLAN Identifier : 1
Stack PortCount : 0
ColdStandby : Disable
Store Default Value : Disable
Hitless Restart Flag : Disable
iBiome Software Version : 1.3.01A17
UBoot Software Version : U-Boot 2016.09 ver 1.30
Switch Name : my_name
Prompt Name : my_prompt
Banner Name :
RM Heart Beat Mode : Internal
RM Redundancy Type : Hot
RM Data Plane Type : Shared
RM Type : OOB
TimeStamp Method : TransHardware
Restore Flag : Enabled
Dynamic Port Count : 28
FIPS operation mode : Disabled
Restore Option : Disabled
Bridge Mode : Customer Bridge
Debugging Log File Location : /mnt/log/
Management Port : Disabled
Automatic Port Create Flag : Enabled
Restore Type : CSR
CLI Pagination : Off
IMG_DUMP_PATH :