Enabling LLDP-MED Network Policy TLV for Destination MAC Address

Type the following:

• Enter the Global Configuration Mode.

iS5comm# configure terminal

• Configure destination mac-address and Enable LLDP-MED Network policy TLV for that specific destination mac-address on port P1.

iS5comm(config)# interface gigabitethernet  0/1

iS5comm(config-if)# lldp med-tlv-select network-policy mac-address 00:02:04:05:06:07

iS5comm(config-if)# end

Type the following:

iS5comm# show lldp local gigabitethernet 0/1 mac-address 00:02:04:05:06:07

Port Id SubType               : Interface Alias

Port Id                       : Gi0/1

Port Description              : Ethernet Interface Port 01

Enabled Tx Tlvs               : Port Description, System Name,

System Description, System Capability,

Management Address

Extended 802.3 TLV Info

-MAC PHY Configuration & Status

Auto-Neg Support & Status     :  ,

Advertised Capability Bits    : 0000

Operational MAU Type          : 0

-Maximum Frame Size           : 1500

Extended 802.1 TLV Info

-Port VLAN Id                 : 1

-Port & Protocol VLAN Id

Protocol VLAN Id     Support    Protocol VLAN Status     TxStatus

----------------     -------    --------------------     --------

0                    Supported  Enabled                  Disabled

-Vlan Name

Vlan Id        Vlan Name                          TxStatus

-------        ---------                          --------

1                                                 Disabled

-Link Aggregation

Capability & Status           : Not Capable, Not In Aggregation

Aggregated Port Id            : 0

-VID TLV:

VID            TxStatus

-------        ---------

1dcdf777       Enabled

-Management Vid TLV:

Vlan Id        TxStatus

-------        ---------

1              Enabled

LLDP-MED Admin Status         : Disabled

-LLDP-MED Capability TLV

LLDP-MED Tx Supported         : MedCapability, NetworkPolicy,

LocationIdentity,

Ex-PowerViaMDI-PSE, Inventory

LLDP-MED Tx Enabled :NetworkPolicy

-LLDP-MED Network Policy TLV

Application Type              :

Unknown Policy Flag           :

VlanType                      :

VlanID                        :

Priority                      :

Dscp                          :

-LLDP-MED Location TLV Info

Location Subtype              :

Location Info                 :

-LLDP-MED Ex-PowerViaMDI TLV Info

Power Priority                : Critical

Power Value                   : 1000

------------------------------------------------------------